Recapture an HTML step
- Open the demo in the editor and select the HTML step that needs an update. Open its capture editor and choose Recapture.
- Check the Recapture page URL. Use a page on the same site and open that exact URL in the active ArcDemo HTML recorder before requesting the capture.
- Arrange the source page in the state the viewer should see. Select Request recapture, complete the capture in the extension, and return to the editor to review the new artifact.
- Inspect the replacement and the editor’s target information. If a target is missing or ambiguous, use Reselect target and choose the intended element; do not assume that a similar-looking control is the correct one.
- Save or discard the capture editor’s pending draft commands as appropriate. Preview the step and the preceding and following steps. Check guides, triggers, and sandbox links that depend on the captured page.
Review a batch of replacements
Where Durable recapture is enabled, the recapture panel can prepare one capture, a selection, a collection, or captures in use. Review the scope preview: it shows the captures and linked demos or steps that may be affected. Start the recapture and follow the recorder’s prompts for each source page. Each replacement becomes a reviewable version. Use Compare to inspect a replacement or Reject to keep the active version. The panel offers two different commit choices:- Commit versions only saves the reviewed versions without applying them to the linked steps.
- Commit and apply confirmed links also applies them to the linked steps in the reviewed usage snapshot. If usage changed since the review, follow the prompt to review and confirm again.